1/9/2023 0 Comments 3dlabprint stl filesI am having adhesion problems, some lines are just falling apart despite being 0.2mm so I may have to up the temp I think. Single wall printing is tricky, 3dlab said so but no real solutions from them for other printers. A save profile would be easier to understand ? I know quitting seems to save it but when I say keep changes I keep getting it wrong, so I have one nearly working then have to start again. I am trying various bits and changes, one problem I have with cura is saving a profile so end up writing them down. I have a large pile of 1cm high sections in various states. I will be a while between relies as (as we all know) prints can take a while. I read where somebody said 3d printing is a hobby within a hobby, good observation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |